4 The difference between aluminum anodizing and chemical anodizing

1. Do you need electricity:

   Anodizing is carried out under high-voltage electrical conditions and is an electrochemical reaction process. Chemical anodizing is a chemical reaction that does not require electricity, just soaking in a potion.

   
   

2. Length of time

   Anodizing takes a long time, generally tens of minutes. And chemical anodizing takes only tens of seconds.

   
   

3. Wear resistance is good or bad

   The film produced by anodizing is several microns to tens of microns, which is hard and wear-resistant. The thin film produced by chemical anodizing is about 0.01-0.15 microns, with poor wear resistance, electrical conductivity, and corrosion resistance.

   
   

4. Conductivity

   Aluminium anodized films are inherently non-conductive. The thin film formed by chemical anodizing is very thin and conductive.

• 

  Three Effective Methods to Improve the Technology of Die Casting Molds

  The design process of die-casting molds is very similar to the design process of plastic molds, and both feed methods and mold structure layouts need to be considered. However, the design of the die-c...
• 

  The first Die Casting Festival

  This is the first "Chuan-Chongqing Die Casting Festival" 1st Chuan&Yu Die Casting Festival will be held in Chongqing, China (Chongqing International Expo Center). From September 2 to S...
• 

  Motor Housing Product Solution

  Current industry status of die-cast motor case processingThe water-cooled die-cast motor housing is generally composed of two die-cast parts: the outer shell and the water jacket. After a series of pr...